Adjustable Marine Electronic Power Supplies – Multi-Current / Multi-Voltage DC for Power LEDs
- Independent IP20 marine power supply, for indoor use.
- Multi-power power supply with DIP switches for output current selection.
- Active PFC.
0–100% brightness control via PUSH function (mains voltage: 170 kΩ):
- short press: switch on/off;
- long press: increase or decrease light intensity;
- adjustment automatically stops at minimum and maximum values;
- for a new on, dimming, or off command, release the button and issue the desired command again.
- Maximum cable length from the pushbutton to the last power supply: 15 m.
- For installations where the cable exceeds 15 m, keep it separate from the 110–240 V mains cable.
- Synchronization cable supplied separately.
- Up to 10 synchronized power supplies, with only one controlled from one or more control points (1 Master + 9 Slaves).
- WARNING: use only normally open pushbuttons without integrated indicator lights.
- 0–100% brightness adjustment via PUSH function, 1–10 V interface (I = 0.35 mA), or 100 kΩ potentiometer.
- Class II protection against electric shock from direct and indirect contact.
- Regulated output current ±5%, including temperature variations.
- Supplied with terminal cover and cable gland.
- Input and output terminals on the same side (maximum cable section: 1.5 mm²).
- Cable glands on primary and secondary for cable diameters from 3 mm to 8 mm.
- Mounting via slotted holes for screws.
Protections:
- thermal and short-circuit protection;
- protection against mains overvoltage;
- overload protection.
- Secondary-side on/off capability for current-driven LEDs (Power LEDs).
- Suitable for powering Power LEDs.
